OMR-50 series low speed high torque hydraulic motors
352/5000
Allowable side load (at rated speed)
Intermittent working pressure refers to the maximum allowable pressure at the entrance, and continuous working pressure refers to the difference in working pressure.
Motors should not be used at the same time at the maximum speed and pressure.
The allowable duration of intermittent pressure or intermittent speed is: 10% of the allowable value per minute at most.
Recommended oil: anti-wear hydraulic oil, viscosity 37-73cst, oil cleanliness iso18/13.
The highest working oil temperature of 80 ° C.
Special dynamic seal design, the maximum back pressure allowed by the motor can reach 10MPa, but in order to obtain a good life and comprehensive performance, it is recommended to use the back pressure does not exceed 5MPa, when exceeding the recommended connection with the leakage pipe, leakage pipe connection, should ensure that the motor can always be filled with oil. The leakage pipeline shall have a certain throttling to maintain the back pressure above 3.5Bar. In addition to maintaining low back pressure, the connection of the drain pipe can also take away the wear and pollution generated in the motor and generate a certain cooling effect.
There should be a run-in period before the full load of the motor, which is recommended to run for 1 hour under 30% of the maximum working pressure.
This series motors other models:
OMR-50, OMR-63, OMR-100, OMR-125, OMR-160, OMR-200, OMR-250, OMR-320, OMR-400, OMR-500
Pressure switch
Chinese
Deutsch
Espanol
Francais
Italiano
Portugues
Japanese
Korean
Arabic
Russian