Axial plunger pump as a professional manufacturer, when you buy the products of our company, we will provide you with excellent customer experience, that certainly would include help you install the plunger pump, axial plunger pump that if you go to other manufacturers to buy and they do not provide plunger pump installation services, don't worry, just by the excellent axial plunger pump manufacturer to tell you the eight steps, let you easily install axial plunger pump.

 

1. Assemble drive shaft components. Install two small bearings and inner and outer spacers at the neck of the drive shaft and lock them with elastic retaining ring;

 

2. Assembly of transmission shaft and pump body. Axial plunger pump manufacturers remind: in the inspection of the end of the pump body, especially with the oil distribution plate combined with the end of the plane, roughness, will drive shaft parts into the pump body hole, requires the shaft rotation on the pump body end of the jump amount is not more than 0.03, and then in the pump outside the end of the oil seal (circular flange);

 

3, docking pump body, pump shell. Make the shaft extend end downward, vertical pump body, and pad with a high solid pad. When docking pump body and pump shell with screws, attention should be paid to the integrity of the size of sealing ring, especially not to lose the small sealing ring at the oil passage interface of pressure control;

 

4, load roller bearing. Pay attention to the uniform bearing force;

 

5. Place the oil distribution tray. Pay attention to the oil tray is placed flat, can use fine copper rod tap (vertical from a certain distance free fall), the sound should be clear;

 

6. Put the cylinder block. Lifting screw shall be used for above 160;

 

7. Put the outer coat, center spring, inner sleeve and steel ball successively;

 

8. Put the plunger and slipper group on the return plate, and then put them vertically into the cylinder block.

 

After listening to the introduction of axial plunger pump manufacturer, is it found that the installation steps are actually very simple? If you need other help, please consult axial plunger pump manufacturer: ZF HYDRAULIC & PNEUMATIC PARTS CO.,LTD

The above: Piston pump enterprises to develop, learning from is the key